-
Junior Member
Reputation: 10
Call Setup Failure 2g
Hi RF Engineers,
Can you help me find initial findings for call setup failure occur on the best area and having a good radio condition. Is actix software can provide me some justification or initial findings? Thanks in advance
Best Regards,
Donato
-
2014-12-12 11:31 AM
# ADS
Circuit advertisement
-
Junior Member
Reputation: 10
Re: Call Setup Failure 2g
Hi Jong,
From your information (i.e good radio condition), please check what is the status of serving cells around that area. You can check HW alarms, transmission issues, any mass event which cause resources scarcity. Check hourly KPIs to see when did it start and if there was any parameter change done in the serving cells.
Regards,
Jeff.
-
Senior Member
Reputation: 386
Re: Call Setup Failure 2g
Originally Posted by
jong
Hi RF Engineers,
Can you help me find initial findings for call setup failure occur on the best area and having a good radio condition. Is actix software can provide me some justification or initial findings? Thanks in advance
Best Regards,
Donato
You can also post the log here for others to analyze and advice...You can also post the log here for others to analyze and advice...
Regards
Scorpion-Learning 5G+4G
No Thanks Please ....But few clicks on Reputation always Welcome :-))
-
Junior Member
Reputation: 10
Re: Call Setup Failure 2g
Thanks Sir. Its a big help for me.
Best regards,
Jong
-
Member
Reputation: 68
Re: Call Setup Failure 2g
Originally Posted by
jong
Hi RF Engineers,
Can you help me find initial findings for call setup failure occur on the best area and having a good radio condition. Is actix software can provide me some justification or initial findings? Thanks in advance
Best Regards,
Donato
from the drive test not complete msg ,so next time if possible you should do a trace IMSI from BSC side
-
Member
Reputation: 96
Re: Call Setup Failure 2g
Check first Traffic vs TCH and SD Utilization.
Bookmarks