-
Member
Reputation: 152
LTE ANR -HANDOVER PROBLEM
Dears,
I have a some problem E-Nobe, When we start the drive test we cant do any handover/intra/inter but when i do warm restart the E-Node, handover start work. How can i check handover attemps/block/drop/request , could you share pmx counter
Best regards.
E-NODE B RBS6102
Last edited by Mali_TR; 2014-12-13 at 02:32 AM
-
Post Thanks - 1 Thanks
-
2014-12-12 07:28 AM
# ADS
Circuit advertisement
-
Member
Reputation: 238
Re: LTE ANR -HANDOVER PROBLEM
could u share the snapshot
-
Member
Reputation: 152
Re: LTE ANR -HANDOVER PROBLEM
why you need snapshot ? and what do you need excaly could you give me more details.
Thanks.
-
Member
Reputation: 238
Re: LTE ANR -HANDOVER PROBLEM
check the ANR feature enabled ?
-
Re: LTE ANR -HANDOVER PROBLEM
What was the setup used during drive test? was the UE doing FTP download continuously?
Was the neighbor already being setup previously (either by ANR or manually)?
-
Member
Reputation: 152
Re: LTE ANR -HANDOVER PROBLEM
ANR enabled.
Drive test
MS1 Dedicated mode ( Download Data)
But Idle mode also same problem...
-
Re: LTE ANR -HANDOVER PROBLEM
If you run FTP DL continuously then i suggest you to use another UE that does ping only. Continuous FTP DL makes the UE very busy and wont have the time to go into DRX and create measurement gaps to measure the neighbor cell E-CGI.
-
Re: LTE ANR -HANDOVER PROBLEM
So does any one knows what the counter is?
"could you share pmx counter"
-
Senior Member
Reputation: 491
Re: LTE ANR -HANDOVER PROBLEM
Originally Posted by
Mali_TR
ANR enabled.
Drive test
MS1 Dedicated mode ( Download Data)
But Idle mode also same problem...
Dear, Do you have the same problem when ANR disabled and use Manual neighbors definitions
Bookmarks