Request for help to use AIRCOM 6.0

[Eugene]

Dear Fellas,

I'm a newbie in using AIRCOM 6.0.

I succeded in installing AIRCOM.
And I could make a project using Jersey map data which is
usually included in AIRCOM demo project.

I can zoom in/out and even make some nodes using my map and project.

I think I have no problem when I do not use separate Visualization
coordiniation.

But when I use Long/Lat visualization,
whenever I hover my mouse over 2D View,
location information which is showing under the map window
is always 00?0'0.00"E 00?0'.00"N.
I think it should change according to position of mouse.

And the location of created facilities are also wrong.
Their Easting and Northing is like 622687, -5527495.

So, If I apply Regional Loading, I can not even remove facilities.

I guess I made some mistake on coordinate conversion or projection.

Is there anyone who knows how to solve this problem?

And Is there anyone who needs my Jersey map data?

Thanks in advance.

Regards,
Eugene

[esahmat]

Dear Fellas,

I'm a newbie in using AIRCOM 6.0.

I succeded in installing AIRCOM.
And I could make a project using Jersey map data which is
usually included in AIRCOM demo project.

I can zoom in/out and even make some nodes using my map and project.

I think I have no problem when I do not use separate Visualization
coordiniation.

But when I use Long/Lat visualization,
whenever I hover my mouse over 2D View,
location information which is showing under the map window
is always 00?0'0.00"E 00?0'.00"N.
I think it should change according to position of mouse.

And the location of created facilities are also wrong.
Their Easting and Northing is like 622687, -5527495.

So, If I apply Regional Loading, I can not even remove facilities.

I guess I made some mistake on coordinate conversion or projection.

Is there anyone who knows how to solve this problem?

And Is there anyone who needs my Jersey map data?

Thanks in advance.

Regards,
Eugene

check coordinate system settings of your project recalculate Map data extents.

[j.afshar]

Dear Fellas,

I'm a newbie in using AIRCOM 6.0.

I succeded in installing AIRCOM.
And I could make a project using Jersey map data which is
usually included in AIRCOM demo project.

I can zoom in/out and even make some nodes using my map and project.

I think I have no problem when I do not use separate Visualization
coordiniation.

But when I use Long/Lat visualization,
whenever I hover my mouse over 2D View,
location information which is showing under the map window
is always 00?0'0.00"E 00?0'.00"N.
I think it should change according to position of mouse.

And the location of created facilities are also wrong.
Their Easting and Northing is like 622687, -5527495.

So, If I apply Regional Loading, I can not even remove facilities.

I guess I made some mistake on coordinate conversion or projection.

Is there anyone who knows how to solve this problem?

And Is there anyone who needs my Jersey map data?

Thanks in advance.

Regards,
Eugene

Visualization Coordinate is just for Connected GPS recieved data over the map.
therfore, i think your problem is actually related to incorrect coordinate system.
you can try this coordinate system, UTM (unniversal transceiver mercator), although, don't forget to choose the appropriate Nothern or Southern information.

cheers