-
Member
Reputation: 126
Throuput Fluctuation On (E)GPRS Cell
Hi
I am working on Nokia equipment. We experienced great variation in throuput on cells where edge is enable.
Although it is not effecting the KPIs but it is noticed during the DT.
This throuput variation is not due to the users we already check it by barring the cell and alow only DT MSISDN.
We have already compare all parameters on TRX, BTS level with another NSN network.
EDAP pool is 6TS
GTRX 1 per Segment
CDED 16%
CDEF 50%
CMAX was 100% Now changed to 60% but same results.
Do anyone experienced this problem before?
Your support will be much appriciated.
Best Regards
Adnan Atif
-
2010-01-07 03:01 AM
# ADS
Circuit advertisement
-
Member
Reputation: 295
Reply
Hi,
I haven't exprienced that problem but what my suggestion is to change your preferred coding scheme to MCS1 or MCS2. Like if your preferred coding scheme for EDGE is MCS6 or MCS7 shift to lower one where ABIS requirement is less. After changing to initial coing scheme and prferred coding scheme then perform the drivetest and check the variations. If no fluctuation is observed then you might be need to expand your E1 link. Sometimes ABIS links are used in compress mode and they dosent support or fullfill the requirements.
Also in last check your abis stats and its stability also.
BR
-
Senior Member
Reputation: 502
EDGE is more senstive to interference and BLER because of the modulation used and also the packet size you download because of link adaptation so concentrate on above and what you getting.
-
Member
Reputation: 126
Originally Posted by
Shakeel_15
Hi,
I haven't exprienced that problem but what my suggestion is to change your preferred coding scheme to MCS1 or MCS2. Like if your preferred coding scheme for EDGE is MCS6 or MCS7 shift to lower one where ABIS requirement is less. After changing to initial coing scheme and prferred coding scheme then perform the drivetest and check the variations. If no fluctuation is observed then you might be need to expand your E1 link. Sometimes ABIS links are used in compress mode and they dosent support or fullfill the requirements.
Also in last check your abis stats and its stability also.
BR
Dear Shakeel
I have done that but still no progress
-
Member
Reputation: 128
dear adnan atif
have you tried RF engineer suggestion?
i mean, how about the interference and BLER?
-
Member
Reputation: 126
Originally Posted by
xcatas
dear adnan atif
have you tried RF engineer suggestion?
i mean, how about the interference and BLER?
It was already checked in our troubleshooting
-
Member
Reputation: 295
Hi
Hi,
So you have tried but you cannot succeed. Sad. The important thing is that the major part of the data optimization is based on PCUSN end and small part on RF end. So, what you have to do raise this case with BSS Planning and Core departments to check the culprit cells, may be there is some discrepacy exisits at their end. Also try to expand E1 Link if the cell is carrying good traffic. Hopefully the issue will resolve.
BR
-
Member
Reputation: 298
read nd perform da test i hope u ll figure out
hye dude just download the doc nd follow the steps/equipment ........its a reocmmended way of testing or troubleshooting +enchancing ur throughput (Nokia)
http://rapidshare.com/files/33191199...r_EGDE-v08.ppt
Regards,
Faib
-
Member
Reputation: 44
Originally Posted by
faib
Re-upload please....
-
Junior Member
Reputation: 7
Originally Posted by
radenmohawk
Re-upload please....
plaese up load this file again , your kindness
Bookmarks