-
Junior Member
Reputation: 10
MTM800E NGCH
I did erase the NGCH memory, after that i do not make the NGCH boot.But I found that I can program in jungo(MIL Programming), but I can only write software, not codeplug.Jungo is only supported below MR5.10,but writing codeplug need dep CPS(like R6D),so is there any other way besides using CPS to write?
-
2024-05-19 10:30 PM
# ADS
Circuit advertisement
-
Member
Reputation: 141
Re: MTM800E NGCH
What you need is DEPOT CPS, like this one on the photo
https://ibb.co/4M60Gyq
-
Member
Reputation: 211
Re: MTM800E NGCH
That is true, be careful with the depot software
Last edited by 580-Gabor; 2024-05-22 at 02:59 PM
Bookmarks