MTM800E NGCH

[Asama1suko]

I did erase the NGCH memory, after that i do not make the NGCH boot.But I found that I can program in jungo（MIL Programming）, but I can only write software, not codeplug.Jungo is only supported below MR5.10,but writing codeplug need dep CPS(like R6D),so is there any other way besides using CPS to write?

[ranengpro]

What you need is DEPOT CPS, like this one on the photo
https://ibb.co/4M60Gyq

[580-Gabor]

That is true, be careful with the depot software