Cleartone CM9000P

[Marco_IU3]

Good evening everyone.

I didn't find anything similar in my forum search

I'm getting closer to the "Tetra" world.

At a flea market I found a cm9000P for a few euros.
the serial number is: CV40046

The frequency should be 410-430 MHz

After finding the cable diagrams I started looking for the software...
I found the NativeProg_205A software which on the first attempt connected the radio to the PC via RS232, but when I press to read the entered data the error indicated "Errorarameter Read (13)" appears and I unhook the radio from the PC.
I tried to change the frequency and power model but it always results in an error


I would appreciate suggestions and help

Thanks
Marco

[ranengpro]

This is very old radio, you will need old pc with win7 os at least.

[580-Gabor]

Chek this therad abot the CM9000:
https://www.finetopix.com/showthread...ht=#post287571

[Marco_IU3]

Thanks for the replies
Renengpro: I used Win 10 Pro as the software started without any problems. I'll try with a Win 7 or XP laptop.


580-Gabor: yes yes I had seen the other discussion and in fact I immediately started looking.
I have the 2.05 software working
I found 2.06 but it requires a login password.
my serial number does not match the ones you wrote, my full label:
model: CM9000P
TEI: 00000404-440046
serial: CV40046
I deduced that since it is a 4 in the number it is the 410-430 version
the backlight is green as you wrote.


I will try as written with WIN 7 or XP and hope for the best


Thanks so much, I'll keep you updated

Marco

[ranengpro]

One thing that is very straightforward, you need to use simple 9 pin serial cable.

Nothing special is needed in regards to connection.

[Marco_IU3]

Good morning everyone, updates!


I managed to connect the radio to the PC but the menus are many and with unknown parameters, I'm trying but it doesn't want to go into tx
Is there some basic file that I can install with parameters already set or some programming manual?


In the meantime, one occasion brought me a Simoco SRM1000 on the table even without parameters installed, but for that I will make a new message hoping that they can communicate with each other...


Thanks and have a good Sunday

Marco