Cleartone CM9000P

[Marco_IU3]

Good evening everyone.

I didn't find anything similar in my forum search

I'm getting closer to the "Tetra" world.

At a flea market I found a cm9000P for a few euros.
the serial number is: CV40046

The frequency should be 410-430 MHz

After finding the cable diagrams I started looking for the software...
I found the NativeProg_205A software which on the first attempt connected the radio to the PC via RS232, but when I press to read the entered data the error indicated "Errorarameter Read (13)" appears and I unhook the radio from the PC.
I tried to change the frequency and power model but it always results in an error


I would appreciate suggestions and help

Thanks
Marco

[ranengpro]

This is very old radio, you will need old pc with win7 os at least.

[580-Gabor]

Chek this therad abot the CM9000:
https://www.finetopix.com/showthread...ht=#post287571

[Marco_IU3]

Thanks for the replies
Renengpro: I used Win 10 Pro as the software started without any problems. I'll try with a Win 7 or XP laptop.


580-Gabor: yes yes I had seen the other discussion and in fact I immediately started looking.
I have the 2.05 software working
I found 2.06 but it requires a login password.
my serial number does not match the ones you wrote, my full label:
model: CM9000P
TEI: 00000404-440046
serial: CV40046
I deduced that since it is a 4 in the number it is the 410-430 version
the backlight is green as you wrote.


I will try as written with WIN 7 or XP and hope for the best


Thanks so much, I'll keep you updated

Marco

[ranengpro]

One thing that is very straightforward, you need to use simple 9 pin serial cable.

Nothing special is needed in regards to connection.