-
2G TCH drop E// problem
Dear engineers,
I have a 2G cell TCH drop problem en E// technology for which I tried several optimizations that didn’t work: the scenario is that the cell is in dense urban area so I limited the TA => abmaxTA, maxTA, TALim and increased rLinkT/rLinkUp and I also accelerated/decelerated some neighbor relations based on their pertinence ==> the TCH drop didn’t decrease (slightly better but still degraded)
The main causes of the drops are Low SS UL & DL
I checked the HW, VSWR, ICMBand, RET and there is no TMA installed in the site ==> there is no HW issue or Interference issue
The BA List is ok, the neighbor list is ok, 3g and 4g co-sector cells are ok (no RSSi problem and no vswr peoblem)
Waiting for your suggestions how to reduce the TCH drop rate, please receive my gratitude
Best rgards.
Last edited by TelecomEng1983; 2023-03-27 at 08:07 PM
-
2023-03-27 08:04 PM
# ADS
Circuit advertisement
-
Senior Member
Reputation: 501
Re: 2G TCH drop E// problem
Originally Posted by
TelecomEng1983
Dear engineers,
I have a 2G cell TCH drop problem en E// technology for which I tried several optimizations that didn’t work: the scenario is that the cell is in dense urban area so I limited the TA => abmaxTA, maxTA, TALim and increased rLinkT/rLinkUp and I also accelerated/decelerated some neighbor relations based on their pertinence ==> the TCH drop didn’t decrease (slightly better but still degraded)
The main causes of the drops are Low SS UL & DL
I checked the HW, VSWR, ICMBand, RET and there is no TMA installed in the site ==> there is no HW issue or Interference issue
The BA List is ok, the neighbor list is ok, 3g and 4g co-sector cells are ok (no RSSi problem and no vswr peoblem)
Waiting for your suggestions how to reduce the TCH drop rate, please receive my gratitude
Best rgards.
Hi, i hawe same in Huawei network, when set maxTA. So, i advice you not use settings of software TA. Better change handover parameters and make higher downtilt of antenna to get smaller TA
Bookmarks