-
Junior Member
Reputation: 10
Problem in Atoll
Hello,
i was using Atoll for planning before with no issue, but now after i download it again and want to start working on it, i tried to make predictions and to calcul them after planing a hexagonal design, the problem here is that Atoll not doing anything an says that "the propagation model does not exist" , even if it worked a year ago i was doing the same simulation without putting any data on the program, but now its not.
Do you guys know where is the issue please ?
Capture d’écran 2022-10-21 235932.jpg
Thank you.
-
2022-10-22 08:00 AM
# ADS
Circuit advertisement
-
VIP Member
Reputation: 2049
1 out of 1 members found this post helpful.
Re: Problem in Atoll
Hi!
can you provide your project in which there is a problem?
-
VIP Member
Reputation: 2780
3 out of 3 members found this post helpful.
Re: Problem in Atoll
Check which model you have in the templates and in the properties of the created sites. Probably there are incorrect settings.
-
Post Thanks - 1 Thanks
-
Senior Member
Reputation: 501
Re: Problem in Atoll
Originally Posted by
dmitry28
Check which model you have in the templates and in the properties of the created sites. Probably there are incorrect settings.
Also, if in project you use aster, you shouod install it additionaly
-
Member
Reputation: 94
Re: Problem in Atoll
You had defined a propagation model name that is not present in the Propagation Models table.
Confirm the name that you have in the transmitters table in "Main Propagation Model" field and compare with the names present in "Parameters - Propagation Models".
Bookmarks