MTP3550 & MTM5400 NOT SWITCHING ON

[c.magnum]

Try Tools...Restore Permanent Disable V2 Radio...I got it like this with my MTP 3200!

[c.magnum]

But see the option mr Bup first, as he has more experience than I do!

[kideoIP]

First, recovery is done via RS-232 cable...

Ok, thanks I have managed to build one. Then from there? there seems to be a file that i need to have because when i try to "detect radio via RS323' it says i must start from ; tools>freon UART> then browse for certain file

[580-Gabor]

Freon UART recovery instructions:


PIN 6 = Flash pin on rear, disconnect power from radio and apply +12V from same PSU as radio is connected to pin 6 on accessory connector with programming lead attached (just go through accessory connector or add another pin)
Start CPS+ Depot
use FREON UART HOST
Custom secure
under AIS file select attached bin file
DO NOT CLICK wait for bootme
when you click START as soon as you press it apply power to radio, timing essential, radio should scroll down messages in window then say DONE, if not keep trying the procedure.
Then you can use "detect radio on rs232 port", write entire codeplug to radio, then write appropriate firmware

[kideoIP]

Freon UART recovery instructions:


PIN 6 = Flash pin on rear, disconnect power from radio and apply +12V from same PSU as radio is connected to pin 6 on accessory connector with programming lead attached (just go through accessory connector or add another pin)
Start CPS+ Depot
use FREON UART HOST
Custom secure
under AIS file select attached bin file
DO NOT CLICK wait for bootme
when you click START as soon as you press it apply power to radio, timing essential, radio should scroll down messages in window then say DONE, if not keep trying the procedure.
Then you can use "detect radio on rs232 port", write entire codeplug to radio, then write appropriate firmware

Thanks, where can i get the AIS file? i see you wrote "attached bin file"

[kideoIP]

does anyone know where i can fin the AIS file ; kernel factory_upstart for an MTM5400? Im atleast trying to restore the mobile, i will deal with the MTP after successfully with mobile

[c.magnum]

Look in the directory where cps depot was installed, bin folder...Look there...maybe it's in the c disk!