Hi friends
I faced problem with model calibration in atoll by DT data. calibration is done but atoll considered a big loss for different clutter classes so the output of calibration is not acceptable. after calibration max coverage is only 300m! I double checked the DT data and that is correct. is there any parameter that I should define or consider before calibration? all steps done based on atoll guide. I used Atoll ver. 3.3.2.11 with med.
any help would be appreciated.
Hi friends
I faced problem with model calibration in atoll by DT data. calibration is done but atoll considered a big loss for different clutter classes so the output of calibration is not acceptable. after calibration max coverage is only 300m! I double checked the DT data and that is correct. is there any parameter that I should define or consider before calibration? all steps done based on atoll guide. I used Atoll ver. 3.3.2.11 with med.
any help would be appreciated.
I think because of high resolution you have a problem, because via calibration for example two different points of CW (different by clutters in real life) lie in the same clutter on map
Assuming that you have a drivetest with RSRP, did you extract the CW from the DT and calibrate after with that? If I remember well the manual was not very explicit how to do some steps.
Some people calibrate the model tunning directly with the imported DT as a CW. It will give you a completely different thing.
In Atoll-3-3-2-Model-Calibration-Guide (you can download the manual here: ) the procedure for calibrating the propagation model is described in sufficient detail. But, in reality, after calibrating the model and performing a coverage calculation, there is a noticeable difference between the real DT measurements and the calculated ones. I was unable to match.
In Atoll-3-3-2-Model-Calibration-Guide (you can download the manual here: ) the procedure for calibrating the propagation model is described in sufficient detail. But, in reality, after calibrating the model and performing a coverage calculation, there is a noticeable difference between the real DT measurements and the calculated ones. I was unable to match.
Thanks for all comments specially my friend @salva121
I found the problem. it was because of main project file. when I imported all sites in new project everything work fine.
Bookmarks