ATOLL 3.4.0 Portable WITH MED!!!

[sak2e]

Where can I find aster setup file?

Did you install aster setup file? You have to install setup file before it will be visible

[gerchase]

Yes in order to have Aster in Atoll you´ll need to have aster installed. Here it is the latest I have, I am sure there would be newer but this one works fine:

http://www.mediafire.com/file/22p5ks....2093.zip/file

[Realman]

thanks for the setup,there should be version higher than Aster x64 2.6.1

[slava121]

Hi!
Is there an Aster version higher than Aster 2.8?
BR

[smartel]

Hi Slava,

I think the last version is 2.8.1 4318

BR

[pl_ev_7]

Hi gerchase,
Small issue with Crosswave. It appears as a license module, it let me create the morphology and facets, but if I try to use it for a prediction it says "no license available". Any idea what could be wrong in my setup?

[dmitry28]

The license is only used at the time of pathloss calculation and model calibration. Your license is probably not valid.

Hi gerchase,
Small issue with Crosswave. It appears as a license module, it let me create the morphology and facets, but if I try to use it for a prediction it says "no license available". Any idea what could be wrong in my setup?

[slava121]

Hi! Which version of Crosswave are you using? What version of Atoll do you use with Crosswave ?

Hi gerchase,
Small issue with Crosswave. It appears as a license module, it let me create the morphology and facets, but if I try to use it for a prediction it says "no license available". Any idea what could be wrong in my setup?

[pl_ev_7]

Hi slava, sorry for delay. I'm using both Atoll and Crosswave from this thread. So Atoll is 3.4.0.15641 and Crosswave is 430.3708b.
If you have any ideas I would be grateful.

[slava121]

For Crosswave IS 430.3708B, have you installed Crosswave.lic license?

Hi slava, sorry for delay. I'm using both Atoll and Crosswave from this thread. So Atoll is 3.4.0.15641 and Crosswave is 430.3708b.
If you have any ideas I would be grateful.