Thanks Thanks:  2
Showing results 1 to 1 of 1

Thread: eNB cannot Send B1 event Measurement Control to UE Because of Wrong Configuration

  1. #1
    VIP Member Reputation: 1141
    Join Date
    2012-08-19
    Posts
    767

    Default eNB cannot Send B1 event Measurement Control to UE Because of Wrong Configuration

    eNB cannot send B1 event measurement control to UE via signaling trace. Because there is no B1 event measurement control UE cannot report B1 event measurement to eNB. Without B1 event measurement report from UE eNB cannot add the SgNB.

    On eNB side we need to configure the parameters named DlArfcn and ScgDlArfcn in these four MOs they are NREXTERNALCELL, NRNFREQ, NRMFBIFREQ, NRSCGFREQCONFIG. The parameters should be configured as the SSB frequency position rather than the center frequency of the cell.

    Change the configurations on eNB side from center frequency to SSB frequency position. Example, NR78 with 100M bandwidth is used, the center frequency is 636666 while the SSB frequency position is 636654 with NARFCN format.

    So during the configuration the parameters mentioned above should be configured as 636654 rather than 636666

    ADD NREXTERNALCELL:Mcc="xx", Mnc="xx", GnodebId=xx, CellId=xx, DlArfcn=636654,UlArfcnConfigInd=NOT_CFG, PhyCellId=xx, Tac=xx;
    ADDNRNFREQ: LocalCellId=xx, DlArfcn=636654, UlArfcnConfigInd=NOT_CFG;
    ADDNRMFBIFREQ: DlArfcn=636654, FrequencyBand=N78;
    ADDNRSCGFREQCONFIG: PccDlEarfcn=xx, ScgDlArfcn=636654, ScgDlArfcnPriority=1;

  2. Thanks esoestemp, kevin_h811 thanked for this post
  3. # ADS
    Circuit advertisement
    Join Date
    Always
    Posts
    Many
     

Bookmarks

Bookmarks

Posting Rules

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •