Thanks Thanks:  0
Showing results 1 to 3 of 3

Thread: Traffic Balance between 3G Layers:

  1. #1
    Junior Member Reputation: 10
    Join Date
    2010-05-26
    Posts
    10


    Default Traffic Balance between 3G Layers:

    this command is used for traffic balancing


    MOD UINTERFREQNCELL:RNCID=310,CELLID=11054,NCELLRNCID=310,NCELLID=11057,SIB11IND=TRUE,IDLEQOFFSET1SN=0,IDLEQOFFSET2SN=0;


    Can anyone tell me how to use this command to push traffic from a layer to another

    Best Regards

  2. # ADS
    Circuit advertisement
    Join Date
    Always
    Posts
    Many
     

  3. #2
    Senior Member Reputation: 402
    Join Date
    2008-08-14
    Posts
    2,756


    Default Re: Traffic Balance between 3G Layers:

    Use this formula:

    MOD UINTERFREQNCELL: RNCId=XXXX, CellId=”High load cell”, NCellRncId=XXXX, NCellId=”Low load Cell”, SIB11Ind=TRUE, IdleQoffset1sn=0, IdleQoffset2sn= -5;

    IdleQoffset1sn: offset for neighbor measured RSCP
    IdleQoffset2sn: offset for neighbor measured EcNo

    If these parameters set to a greater value, the probability for selecting the neighboring cell as the target cell reduces. If these parameters set to a smaller value, the probability for selecting the neighboring cell as the target cell increases.

  4. #3
    Senior Member Reputation: 695
    Join Date
    2014-03-10
    Posts
    475


    Default Re: Traffic Balance between 3G Layers:

    dears
    this configuration is useful if you have continus coverage for all 3G Frequency,thanks

    Quote Originally Posted by Meek View Post
    this command is used for traffic balancing


    MOD UINTERFREQNCELL:RNCID=310,CELLID=11054,NCELLRNCID=310,NCELLID=11057,SIB11IND=TRUE,IDLEQOFFSET1SN=0,IDLEQOFFSET2SN=0;


    Can anyone tell me how to use this command to push traffic from a layer to another

    Best Regards

Bookmarks

Bookmarks

Posting Rules

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •