-
Junior Member
Reputation: 10
Traffic Balancing
Hi,
I have a 3G site with 3 cells, two of these cells is having a very high traffic, I'd like to push traffic to the cell with low traffic in both idle and dedicated modes, I also want to make handover from the other cells little bit hard, any suggestions about the required parameters or feature?
Thanks
-
2019-04-11 07:43 PM
# ADS
Circuit advertisement
-
Junior Member
Reputation: 13
Re: Traffic Balancing
You can tune compressed mode parameters
And you can use hsifls feature in E******* and let's fast the load sharing by tune hsiflsuserth
-
Member
Reputation: 47
1 out of 1 members found this post helpful.
Re: Traffic Balancing
well, if the vendor is huawei... when you have for example 2 layers (2 freqs) and co-sector (means similar coverage) you get cells balanced automatically in rrc as part of a load balancing feature.
if you have only 3 cells i assume the coverage of every cell is different how can you expect to push traffic there ?
in any case there´s a load intrafreq balancing feature as part of LDB algorithm in huawei...
which vendor is your case ? and also, which coverage those 3 cells have ? you cant push traffic if coverage is different
-
Junior Member
Reputation: 11
Re: Traffic Balancing
You must try with a features of load balance and tune it.
Also you can try modify parameters like QHyst, sIntraSearch, sInterSearch.
It’s important you put the relation’s inter and intra.
-
Senior Member
Reputation: 491
Re: Traffic Balancing
Originally Posted by
Meek
Hi,
I have a 3G site with 3 cells, two of these cells is having a very high traffic, I'd like to push traffic to the cell with low traffic in both idle and dedicated modes, I also want to make handover from the other cells little bit hard, any suggestions about the required parameters or feature?
Thanks
Are these High & low traffic cells covering same area or different area?
Bookmarks