xcal-m setup (v3.3.6.121) and xcap-m-5.12.1.0 installers only
Hi guys this time I would like to share with you xcal-m (v3.3.6.121) and xcap-m-5.12.1.0 installers only in this file you will also find additional patches to install after the installation of each set up , I must say that I am only sharing the set up files I do not have the med or any licgen, perhaps someone in the forum can help to create an emulator for these two softwares. in my particular case I Need and emulator for xcal-m setup (v3.3.6.121) and xcap-m-5.12.1.0 that has LTE SEQUANS CHIPSET integrated.
Re: xcal-m setup (v3.3.6.121) and xcap-m-5.12.1.0 installers only
License (XCAL-M, XCAP-M) and emulator (x86, x64) attached below.
After installing them Photo_1
the XCAL-M 3.3.6.131 starts smoothly Photo_2
Originally Posted by Jose1975
in my particular case I Need and emulator for xcal-m setup (v3.3.6.121) and xcap-m-5.12.1.0 that has LTE SEQUANS CHIPSET integrated.
You can try to install your expired license for LTE Sequans chipset with the emulator found by me. This emulator works with the expired license found by me Photo_3
Therefore, there is a chance that it will work with your expired license.
Requests to forum members:
1. From the helpdesk http://help.usa.accuver.com/helpdesk/
it follows that there are available newer XCAL-M 3.4.0.x versions from 2017. If someone has a XCAL-M 3.4.0.x, please share it on the forum.
2. The license found by me supports LTE Qualcomm chipset with 2CA Photo_8
If someone has a license which supports LTE Qualcomm chipset with 3CA, please share it on the forum.
3. The license found by me does not support LTE Samsung chipset (Exynos) and LTE HiSilicon chipset (Balong). If someone has a license which supports LTE Samsung chipset (Exynos) or LTE HiSilicon chipset (Balong), please share it on the forum.
4. Consider adding a reputation for me. The working XCAL-M 3.3.6.131 from 2016 (and probably also the XCAP-M 5.13.51.0 - I have not installed and tested it) shared by Jose1975 definitely deserves for that.
After careful application of installation steps 'xcal-m setup (v3.3.6.121) and xcap-m-5.12.1.0' explained in packages provided by Forum. I'm unable to successfully activate either
XCAL-M or XCAP-M using the license keys provided on my Windows 7 Ultimate - 64bit PC. As seen below, complete with Sentinel v768 already installed.
PS - also observed "Device Driver Notifications - Not Appearing as normal'
From the screenshoot it looks that the problem is DSEO. There is a mistake in an original guide, which I didn’t notice earlier. You should type C:\Windows\System32\drivers\multikey.sys under ‘‘Sign a System File’’.
Bookmarks