-
Member
Reputation: 31
RET checking in NetAct
Dears,
Could you please help me how I can report all RET status through NetAct? I know how to check site by site using site IP but no idea how to do it in one step.
Your help appreciated.
Ela
-
2015-08-30 04:45 PM
# ADS
Circuit advertisement
-
Senior Member
Reputation: 361
Re: RET checking in NetAct
Do you mean value of RET? You can find the "Angle" value in Dump, under LNCEL or RET.
Best people are those who are useful to others
-
Re: RET checking in NetAct
Originally Posted by
elahetal
Dears,
Could you please help me how I can report all RET status through NetAct? I know how to check site by site using site IP but no idea how to do it in one step.
Your help appreciated.
Ela
Use the table A_WBTSF_RET for finding RET values. From serNum you will know the band of the antenna ( 900, 1800, 2100 : the last digit normally tells which band it is. You will know it from the antenna manufacture)
You need also the table A_WBTSF_RET_ANTLIDLIST to know the sector number from the antlIdList.
-
Member
Reputation: 31
Re: RET checking in NetAct
HI, Tanks for your reply, but I can not find LNCEL in dump. our RNC is RU40
-
Member
Reputation: 31
Re: RET checking in NetAct
Hi, could you please address me where I can find A_WBTSF_RET ?
-
Re: RET checking in NetAct
From the MS access dump if you are using the plan editor to parse the dump.
If you are using some other tool to parse the dump then the table name according to your tool.
-
Member
Reputation: 31
Re: RET checking in NetAct
Hi,
I am using NePa for parsing and I couldn't find ant RET value inside. Can it be related to not configured RET?
-
Re: RET checking in NetAct
Originally Posted by
elahetal
Hi,
I am using NePa for parsing and I couldn't find ant RET value inside. Can it be related to not configured RET?
It can be, but I think NePa doesnt parse the RET table, try using Netact Plan Editor.
Also you can open the CM Editor from Netact and check the RET from there.
Also note that RET for WCDMA cells can been seen from the WCEL table, there is field with name 'ángle' which gives the tilt (divide it by 10).
Check from the Nepa output the WCEL table and see if you have any value in the angle field, if no then RET is not configured.
-
Member
Reputation: 296
Re: RET checking in NetAct
NOKIA dumps are easy to parse to tables, but you will need to prepare some queries linking few tables to get the RET values associated to cells.
Bookmarks