Most drive testing tools, including TEMS, Couei, ROMES, Nemo etc support the Qualcomm chipset.
99% of Samsung 3G phones use Qualcomm chipsets and hence can be used with the above tools.
In order to do this follow this procedure..
1. DL the Qualcomm driver pack from...
http://rapidshare.com/files/22509583...Driver2040.exe
and install it. Note: this will just unpack the driver files at a specific location.
2. Connect the Samsung phone to your laptop via USB cable using the drivers that came with the phone.
3. Using the hyperterminal application connect to the modem port of the phone (to see what modem port number Windows has assigned use Device Manager)
4. Once connected via hyperterminal type the following command..
AT$SUSBC=1
5. The Qualcomm diagnostic interface will be activated and Windows will ask you for the drivers (you might need to disconnect/re-connect the USB cable). Point the Found New Hardware Wizzard to the folder that was created in step 1.
6. That is it. If you look in Device Manager now you will see that there is one Qualcomm modem enabled and one Qualcomm diagnostic port enabled. Point all DT tools to the diagnostic port to view messages etc.
7. If you ever want to disable the Qualcomm diagnostic interface and revert back to normal "Samsung mode" follow the same procedure but type AT$SUSBC=0
Hope this helps somebody..
By the way, if you ever need to enable the Qualcomm diagnostic interface on a Huawei product use the following command (again via hyperterminal) AT^U2DIAG=0
Bookmarks