Dear
I need help, we already swaped to Huawei SRAN BSC6900 and I really confiused in KPI names so can you help to fine below KPIs:-

1- Call Setup Success Rate (The CALL_SETUP_SUCCESS_RATE statistic tracks the percentage of call attempts that result
in a successful TCH access. Network accesses which do not require a TCH are excluded, for
example, location updates, SMS, and Supplementary Service attempts.)

2- Totals calls as number not Erlang (The TOTAL_CALLS statistic tracks the total number of calls originated for each cell on the BSS)

3- Handover Ruccess Rate (The HANDOVER_SUCCESS_RATE statistic tracks the percentage of handovers attempted from
the source cell (cell for which the statistic is presented) that successfully reached the target cell.
A handover attempt is counted when a handover command is sent to the MS. This key statistic
includes inter-BSS Handover and the 2G->3G Handover (because of OUT_INTER_BSS_HO
includes 2G->3G handover).

4- Drop Call Rate (The DROP_CALL_RATE statistic tracks the percentage of MSs which have successfully
accessed a TCH, and experience an abnormal release caused by either radio or equipment
problems. This includes RF losses and losses during handovers.)

5- Handover Failure Rate (The HANDOVER_FAILURE_RATE statistic tracks the percentage of handovers that are
attempted from the source cell (the cell for which the statistic is presented) that failed to
successfully reach the target cell and failed to successfully recover to the source cell, that is,
the handover failed and the call dropped. A handover attempt is counted when a handover
command is sent to the MS.)

6- TCH Blocking Rate (The TCH_BLOCKING_RATE statistic provides the percentage of all requests for TCH resources
(originations and handins) which fail due to no available TCH resources.)

7- TCH Congestion Rate (The TCH_CONGESTION statistic indicates the amount of time that no full rate TCH channels
were available in that cell.)

8- SDCCH Blocking Rate (The SDCCH_BLOCKING_RATE statistic tracks the percentage of attempts to allocate an
SDCCH that were blocked due to no available SDCCH resources. This statistic includes
incoming SDCCH handover attempts.)

9- SDCCH Congestion Rate (The SDCCH_CONGESTION statistic tracks the amount of time that no SDCCH channel was
available in a cell.
10- carreid Traffic (The TCH_TRAFFIC_CARRIED statistic tracks the mean number of busy TCHs.)



Thank you in advance

Best Regards