-
Member
Reputation: 37
LLC Low Throughput
Hi,
Anyone has knowledge on how to optimize or what counters should I check to analyze LLC Low Throughput. I am using Huawei system.
Br//
-
2012-12-12 12:06 PM
# ADS
Circuit advertisement
-
Member
Reputation: 37
Re: LLC Low Throughput
Hi,
Up. Anybody can help me about this? Or anyone has a document which I can read.
Thanks!
-
Member
Reputation: 35
Re: LLC Low Throughput
Hello,
Have you checked the Flow control parameters?
It is the BSC that sets the flow control parameters for a session, so, if you have no bandwidth issues between SGSN and BSC, the troubleshooting should be done on BSC side.
On the SGSN you can check these parameters using DSP PTPBVC command.
Read the 3GPP TS 48.018 for details about Flow Control data. Search for MS Bucket Size and Bucket Leak rate.
Best Regards.
-
Member
Reputation: 37
Re: LLC Low Throughput
So you mean it is in a bsc level? If only I have Llc low throughput in one cell and the others is okay.
-
Re: LLC Low Throughput
the RLC throughput is low too for this cell??
check the MCS usage and the RLC blocks retransmission rate, if you don't have a problem there check if there's heavy CS traffic on the cell or the cell resources are not enough(the number of TRXs and the transmission link).
-
Member
Reputation: 37
Re: LLC Low Throughput
Is there any counters in M2000 should i look into?
-
Member
Reputation: 35
Re: LLC Low Throughput
Hi,
As stated above by our colleague MHDRF check the relevant KPIs in M2000.
A search in Hedex will head you in the right direction.
-
Junior Member
Reputation: 10
Re: LLC Low Throughput
I'm not familiar with Huawei,but generally low throughput comes from lack of PDH's in abis and air interface,so its better to check the assighed PDCH's to each user in a cell(4 pdch=232Kb),besides plase check the share of each MCS's in the kpi,if higher MCS's have little share so besides the avalable resource checking,notice to the C/I in that cells and also the default MSC after a tbf stablished
-
Member
Reputation: 61
Re: LLC Low Throughput
I have seen this happening because of incorrect configuration of QoS for the subscriber. Make sure that LLC is Unack mode and RLC is Ack mode.
Bookmarks