UMAT3800

[Handover24]

Guys,
I do not know what to say...I've to try your files by myself and then it will be clearer.
ayman.absi maybe your UMAT version does not support that LMT or your settings aren't ok( I do not know your UMAT version or your settings. to use mine I had to change the default settings but now I do not know what I did about 2 months ago )
topoffenders I've never open a GCHR file with UMAT but shar ewith me that file and I will try to help you.
Regards.

[ayman.absi]

I've run it for 2G call trace "Single CS user". Is it OK?

[Handover24]

Yes it is ok ... if you share the file I could give you a deeper help.
Let me know.

[ayman.absi]

Yes it is ok ... if you share the file I could give you a deeper help.
Let me know.

Below is the trace file. Could you please help me analyzing it?
16777664_Single User CS Trace_20121118_123512+0300_0.tmf.zip

[zefs]

Below is the trace file. Could you please help me analyzing it?
16777664_Single User CS Trace_20121118_123512+0300_0.tmf.zip

I succeeded in opening your trace file with this version of UMAT.
The thing is that you have to move the "common" and "V900R013C00SPH526" to a new folder, name it "​BSC6900".

Open trace.

[zefs]

Is this tool going to support the UGW and MME traces ever?

[ayman.absi]

I succeeded in opening your trace file with this version of UMAT.
The thing is that you have to move the "common" and "V900R013C00SPH526" to a new folder, name it "​BSC6900".

Open trace.

Yes. It is opening now, Thanks Zefs. I've choosed LOCAL from below snapshot.

19-11-2012 12-05-36 PM.jpg

Now, we need an expert to show us how to jump to call drop event

[zefs]

Yes. It is opening now, Thanks Zefs. I've choosed LOCAL from below snapshot.

19-11-2012 12-05-36 PM.jpg

Now, we need an expert to show us how to jump to call drop event

You can use the filter by column feature.
Bring the mouse pointer to Type column, right mouse click, choose "Filter by column", find the desired message, note its number, than un-filter, find message by number and so on...
filter.gif

Best Regards

[ayman.absi]

You can use the filter by column feature.
Bring the mouse pointer to Type column, right mouse click, choose "Filter by column", find the desired message, note its number, than un-filter, find message by number and so on...
filter.gif

Best Regards

Thank you Zefs,

This is very useful.
Now, If I filter for example "Clear Commands" How can I find the abnormal clear commands (for example non-call control like equipment failures)?
If you've document for analyzing abnormal events, please share it.

[zefs]

Thank you Zefs,

This is very useful.
Now, If I filter for example "Clear Commands" How can I find the abnormal clear commands (for example non-call control like equipment failures)?
If you've document for analyzing abnormal events, please share it.

Unfortunately I do not have such information.

UMAT does not allow for "Content" column filtering, too bad.

But there is a solution to any problem:
1. apply a filter, let's say "clear command".
2. right click on any message, select "Export the all messages in the listbox to TXT..." (wrong grammatically, but does the job )
3. open the file with Notepad++ (or anything similar) and search for needed strings.

This way I found that at 2012-11-18 12:36:18 was sent a Clear command with cause cause-value7:radio-interface-failure (1).

Best Regards