Changing the maxDlPowerCapability for E******* RBS

[senjamir]

Hi,

Im trying change the maxDlPowerCapability from 430 to 460 in the E******* equipment. When i execute the command
set NodeBFunction=1,RbsLocalCell=S1C1 maxDlPowerCapability 460

Im getting the error:
!!!! Processing failure :se.e*******.cello.moframework.NoSuchAttributeException TAG :"NoSuchAttribute" VARIABLES :"$attrName" = "maxDlPowerCapability", "$moTypeName" = "RbsLocalCell"

Just an additional info:
1. the license for 40 watts is already activated
2. maxtransmissionpower 460 and cpichpower 360 already in the utrancell in RNC

I also tried the command "rset NodeBFunction=1,RbsLocalCell=S1C1 maxDlPowerCapability 460" but im still getting the same error.

Thanks,
Sen

[wolverine]

This parameter is read only. Hence why you cannot set it.

[shamim23]

Yes as Wolverine said, maxDlPowerCapability can not be directly configured. Its value is function of Power at RBS Ant Port (PRAP) and Losses:

maxDlPowerCapability = PRAP – DLattenuation(TMA) – Dlattenuation(Feeder)

Hope this helps.

[senjamir]

Hi,

If that is the case. Can i set it by changing other parameters that will affect it?

Thanks and Br,
Sen

[shamim23]

Yes dear Sen but please use values from sweep test for feeder losses and also for electrical delay. One can also use given formulae in Alex for such calculation but sweep results are recommended.

ATB