Thanks Thanks:  1
Showing results 1 to 2 of 2

Thread: SDCCH Handover

  1. #1
    Member Reputation: 322
    Join Date
    2011-05-18
    Posts
    241


    Default SDCCH Handover

    Kindly tell the negative effects of enabling SDCCH HO in ******** or is it preferred in any other Vendor. Thanks.

    SDCCH Handover:
    It is possible that an MS using an SDCCH slot has to perform an inter-cell or intra-cell handover.bThis need is calculated by the HDPC algorithms using uplink and downlink measurement reports in the normal way. One important item to note is that the interference band allocated to a channel is still the first criterion in the channel allocation algorithms. A channel from the highest priority carrier matching the requested interference band is allocated to a channel request. Moreover, the channel allocation priority is also a secondary criterion after the existing criteria of channel selection in a multiband, concentric cell and extended range cell environment. Also, the channel
    allocation priority can not be followed for an emergency call if a channel is allocated from the emergency reserved channel pool. For interference-based intra-cell handovers, the channel selection algorithm for a non-hopping
    cell has been modified to consider the channel allocation priority as follows:

    • Compile a list A with any channels in the best interference band.
    • From list A, select any channels on a carrier other than the current carrier and compile a
    list B. If none are available, select the best channel from list A.
    • From list B, select a channel with the best available channel allocation priority.

  2. # ADS
    Circuit advertisement
    Join Date
    Always
    Posts
    Many
     

  3. #2
    Member Reputation: 461
    Join Date
    2008-09-26
    Location
    World
    Posts
    392


    1 out of 1 members found this post helpful.

    Default Re: SDCCH Handover

    Bro,

    SD HO like TCH HO helps to reduce drops (SD Drops), by allowing mobile to move to a cell with better radio conditions,

    two parameters comes into play:

    sdcch_ho: wich enables or desables the feature
    sdcch_timer_ho: wich specifies the wait time (measured in SACCH multiframes) before a handover on the SDCCH may occur

    handovers are not allowed until at least (sdcch_timer_ho * 2) measurement report periods have elapsed

    the later parameter is a customized ******** parameter
    handover_required_curr_ch should be set to 1 to allow SD HO between MSCs

    if configured correctly, I don't see any negatif side for enabling this feature

    Regards,

    a little click on is very appreciated
    Last edited by peanut; 2012-05-23 at 02:31 AM

Bookmarks

Bookmarks

Posting Rules

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •