ploting Neighbors

**husseinmanaf** · 2012-05-03, 07:46 PM

Hi

brothers, i want to ploting nieghbors rxlevel and its for wich cell, in tems inves. there is window " GSM Serving + Neighbors " show us nieghbors and cell info with rxlevel, how an i get those valuse please...

Thankx in advance

**Finetopix** · 2012-05-03 07:46 PM

**bino** · 2012-05-04, 11:30 AM

Originally Posted by husseinmanaf

Hi

brothers, i want to ploting nieghbors rxlevel and its for wich cell, in tems inves. there is window " GSM Serving + Neighbors " show us nieghbors and cell info with rxlevel, how an i get those valuse please...

Thankx in advance

Hi,

I think you should export tems logfile to mapinfo (neighbor name, CI, rxlev,...).

Br.

**pashcal** · 2012-05-04, 02:37 PM

Originally Posted by bino

Hi,

I think you should export tems logfile to mapinfo (neighbor name, CI, rxlev,...).

Br.

Yes, and don't forget coordinates, if you want to make dotted objects in MapInfo, colored by RxL!

**lejun** · 2012-05-04, 10:53 PM

Originally Posted by husseinmanaf

Hi

brothers, i want to ploting nieghbors rxlevel and its for wich cell, in tems inves. there is window " GSM Serving + Neighbors " show us nieghbors and cell info with rxlevel, how an i get those valuse please...

Thankx in advance

Hi friend,

This is because of your cellfile (you must have all information: serving cell, neighbors cell with LAC, CI,BCCH.... get from system). We usually write a macro for Tems cellfile.

Best Regards

**husseinmanaf** · 2012-05-05, 12:42 AM

Thanks Brothers

I tried in actix and Mapinfo too..

i will explain if you conect in cell and you take signal from this cell and there are niehbors in same dot.

I want to represent each niegbor of this dot or if ican take vlue of rxlevel with out ploting no issue too.

Thanx brothers

**indoor** · 2012-05-09, 09:58 PM

I needed to do this recently with mapinfo, whilst Actix looked like the best way, because I was using indoor pin point results it didn't like it and only gave a few points across the floor plan.

I ended up exporting the log file for the GSM handset with neighbour cell ID, rx lev for the neighbour and coordinates. to a CSV file, with columns for each of the 18 neighbours.

This was then cleaned up in excel using the filter to copy and paste into a new sheet the levels and the coordinates. I'm sure a simple macro in excel would have been able to get all the results. I was very impressed at the amount of info hidden away in the log file though as it saved me another trip to site