-
VIP Member
Reputation: 1216
3 out of 3 members found this post helpful.
ploting Neighbors
Hi
brothers, i want to ploting nieghbors rxlevel and its for wich cell, in tems inves. there is window " GSM Serving + Neighbors " show us nieghbors and cell info with rxlevel, how an i get those valuse please...
Thankx in advance
Thank You So Much For Click helpful or add reputation
-
2012-05-03 07:46 PM
# ADS
Circuit advertisement
-
Senior Member
Reputation: 313
Re: ploting Neighbors
Originally Posted by
husseinmanaf
Hi
brothers, i want to ploting nieghbors rxlevel and its for wich cell, in tems inves. there is window " GSM Serving + Neighbors " show us nieghbors and cell info with rxlevel, how an i get those valuse please...
Thankx in advance
Hi,
I think you should export tems logfile to mapinfo (neighbor name, CI, rxlev,...).
Br.
Last edited by bino; 2012-05-04 at 11:32 AM
-
Re: ploting Neighbors
Originally Posted by
bino
Hi,
I think you should export tems logfile to mapinfo (neighbor name, CI, rxlev,...).
Br.
Yes, and don't forget coordinates, if you want to make dotted objects in MapInfo, colored by RxL!
-
VIP Member
Reputation: 1289
Re: ploting Neighbors
Originally Posted by
husseinmanaf
Hi
brothers, i want to ploting nieghbors rxlevel and its for wich cell, in tems inves. there is window " GSM Serving + Neighbors " show us nieghbors and cell info with rxlevel, how an i get those valuse please...
Thankx in advance
Hi friend,
This is because of your cellfile (you must have all information: serving cell, neighbors cell with LAC, CI,BCCH.... get from system). We usually write a macro for Tems cellfile.
Best Regards
-
VIP Member
Reputation: 1216
3 out of 3 members found this post helpful.
Re: ploting Neighbors
Thanks Brothers
I tried in actix and Mapinfo too..
i will explain if you conect in cell and you take signal from this cell and there are niehbors in same dot.
I want to represent each niegbor of this dot or if ican take vlue of rxlevel with out ploting no issue too.
Thanx brothers
Last edited by husseinmanaf; 2012-05-14 at 01:40 AM
Thank You So Much For Click helpful or add reputation
-
Member
Reputation: 269
Re: ploting Neighbors
I needed to do this recently with mapinfo, whilst Actix looked like the best way, because I was using indoor pin point results it didn't like it and only gave a few points across the floor plan.
I ended up exporting the log file for the GSM handset with neighbour cell ID, rx lev for the neighbour and coordinates. to a CSV file, with columns for each of the 18 neighbours.
This was then cleaned up in excel using the filter to copy and paste into a new sheet the levels and the coordinates. I'm sure a simple macro in excel would have been able to get all the results. I was very impressed at the amount of info hidden away in the log file though as it saved me another trip to site
-
BannedUser-MultiAccounts
Reputation: 33
Re: ploting Neighbors
May I ask you to show me the result capture Sir, in case we'll need it someday
Thx
Bookmarks