Huawei define these three different timers for fast dormancy
PsInactTmrForFstDrmDch specifies the PS inactivity timer for CELL_DCH. default value-4s
PsInactTmrForFstDrmFach specifies the PS inactivity timer for CELL_FACH. default value-10s
PsInactTmrForPreFstDrm specifies the PS inactivity timer for CELL_PCH.default value-360s
Huawei define these three different timers for fast dormancy
PsInactTmrForFstDrmDch specifies the PS inactivity timer for CELL_DCH. default value-4s
PsInactTmrForFstDrmFach specifies the PS inactivity timer for CELL_FACH. default value-10s
PsInactTmrForPreFstDrm specifies the PS inactivity timer for CELL_PCH.default value-360s
Mobile side implmentations usually keep the timer between 3 to 7 seconds, with 5 seconds being almost a widely accepted value.
This is for Rel-7 implementations. With Rel-8 support for fast dormancy, the mobile vendors may reduce this timer to 3 seconds.
Note that in Rel-7 or earlier, the mobile on triggering Signalling connection release (fast dormancy) will go back to Idle state, so the DCH/FACH etc. timers don't apply.
Last edited by chamanbagga; 2012-03-05 at 04:34 PMReason: additional information
Bookmarks