-
Member
Reputation: 120
[HELP] How to improve call setup time in 2G?
Hi experts! I'm optimizing indoor cell site and my problem was long call setup time.
I recorded 7s and I need to make it at least 5s. The equipment was only a 2W Repeater.
Can somebody help me with my problem?
Thank you very much for the support.
-
2012-02-07 11:33 AM
# ADS
Circuit advertisement
-
Member
Reputation: 54
Re: [HELP] How to improve call setup time in 2G?
It depends upon many factors mainly from core side.
Yet on radio side you can reduce MFRMS to 2 for indoor cells it will reduce call setup time for MT (mobile terminating calls).
If you can conveince CORE, you may trun off ciphering. Then benchmark your call setup time, you will surely come near to 5 secs.
BR//
Imran
-
Re: [HELP] How to improve call setup time in 2G?
Hi, some trick about cst :
1. make sure the terminating number is not prepaid, since it will come to IN which take delay, also to use the same HLR id
2. Reduce the Nbr of multiframe between paging
3. Turn off imei check (in MSC)
4. Try to make a call under indoor antenna
But i think 7 s is fair for 2G, 5 s in average is difficult. But you can try above.
-
1 out of 1 members found this post helpful.
Re: [HELP] How to improve call setup time in 2G?
Here is great guide from Huawei about reducing Call Setup Time in GSM: GBNK.CST.OM.rar
Maybe this will help you find the solution.
-
Re: [HELP] How to improve call setup time in 2G?
thanx for help on How to improve call setup time in 2G
-
Member
Reputation: 238
Re: [HELP] How to improve call setup time in 2G?
Hi
increase authentication counter value
i.e after intail call next authentication is on next 10 th call...
2) if ciphering is enabled can disable it.
3)FACCH call setup
regards
Plannerguy
-
Junior Member
Reputation: 13
Re: [HELP] How to improve call setup time in 2G?
Bookmarks