CDMA Radio Network Optimization Plot Analysis (using Actix)

[honhungoc]

Everyone, share your experience please
With me, i usually analyzer CDMA logfile by some steps:
1. See KPIs:
In CDMA we have 4 essential KPI: Ec/Io, Rx, Tx, Forward FER.
Firstly, we must define the value of these KPI, you can see in this thread.
Or you can see in book: RF200, find in http://www.howcdmaworks.com/
It is a wonderfull book in CDMA optimization network field.
By seeing KPI, we know some problem in our network
In some situation, we can define problem clearly from these KPIs
For example:
Ec/Io poor, Rx poor: coverage problem, then place some sites or change antenna...
Ec/Io poor, Rx good: pilot poluttion, it is a complex problem, especially in a large city.
....
Sometime, we need see some PN in area that have problems and active set PN...
And many other situation, you can see problem and solution in RF200 or in attached file
2. See events data
Failed calls, dropped calls, handoff...
3. Find the cause of these events
We must understand signalling messages, critical parameters in these messages, call processing by message... RF200 Please
Actix have a powerful function: synchronize events data with signalling message, map... It will help us.
In next post, i will have a example for more clearly
If i have some mistake, please correct it for me
BR

its a good website but its impossible to get the tutorials

[da_manole]

its a good website but its impossible to get the tutorials

http://www.howcdmaworks.com/drophelp2.htm

[ithink]

welldone, deep analize,

just add, you can try to decrese pilot gain, from 225 to 222, or you can check Cell radius, maybe too big for urban area, ( 384 or 512)