E******* Mini Link Craft 1.1

[Cost_Reducer]

here are both software versions

don`t forget to add reputation for me

[rainbow]

thanx fo cost reducer..
ur the best
its very hard to find this software...

many thanx 4 u, sorry i can't give reputation ( newbie mode :ON )

[ofca]

I already did and it said I can't give you any more now

[Cost_Reducer]

...it`s right, it is very difficult to get software for E******* products.
So this forum is the best place to share it with other members.


Regards,

CR

[ofca]

Aye, this forum is excellent. Glad I found it. And I'm glad you guys found it cost_reducer, and itsartur

[ofca]

Fighting continues...
@Cost_Reducer: Could you check what release you have for MMU for R4.2?
It's CXP9011133_4.

Also, do you use some kind of MSN, Jabber or smth? I would be able to stop the pointless forum trashing :>

[ofca]

OK, disregard. It was just me being stupid. Note to self: DCN Only = Bad.

[Cost_Reducer]

OK, disregard. It was just me being stupid. Note to self: DCN Only = Bad.

Hy ofca,

how do you mean, "DCN Only = Bad"
Do you have configured the MMU at "DCN only" ?

If i have the time tommorow evening, i will share product description of release 4.3.1 with you

[ofca]

Yes, I had the 'DCN Only' option enabled, not exactly knowing it's function. After short RTFM session I was much smarter, and disabling it made the problem go away. Well, error description could be a bit more descriptive - funny thing to note is: it was a problem only on newer firmware release - old MMU firmware worked fine anyway.

About product description: please do, at least I'll have something to look forward to

[Feriko]

Hello everyone,

I just want to make a question about this software...

What advantages does it have above the "traditional" web connection?

Thanks!