E******* Mini Link Craft 1.1

[ofca]

I need RAU2 X (CXP 901 2878) Release R1E if you have it somewhere.

[itsartur]

I need RAU2 X (CXP 901 2878) Release R1E if you have it somewhere.

http://www.megaupload.com/?d=0BNHKGLU

[ofca]

Now that was quick, useful and unexpected - thank you very much!

[ofca]

Thanks, it worked flawlessly and upgraded the RAUs. Could you perhaps post the whole Baseline R13A13 (CXP9010021_1) or at least MMU2D (CXP9011133/4) firmware R5A16 or newer?

[Cost_Reducer]

Ho Ofca,

R5A16 is from R4.2FP. I can upload this today....
btw...someone can upload ml-craft 2.5 and R4.3?

regards,

[Cost_Reducer]

Hi,

R5A16 is here !

[itsartur]

any time @ofca.

[ofca]

After upgrading both MMU and RAU, even without using 56MHz channels, I couldn't transmit any data over radio link. WAN interface reported 'lower layer down' and that's that. After downgrading MMU back to old release, everything went back green. Incompatible releases somewhere else?

Cost_Reducer, maybe you could post whole R4.2?

I'd also love to get MLCT2.5 and R4.3 :>

[Cost_Reducer]

hi ofca,

certainly i can share it here...this weekend?
Yes, it`s mandatory to use the same baseline / module software on both terminals. All modules must have the same baseline like the NPU!
Try this...i know that E\\\ have big problems with the co-operations between MLTN hardware and the different software revisions.

Regards

[ofca]

Glad to hear it; thought something was unexpectedly wrong. In that case it would seem, that I need two last things:

CXCR102051_1 and CXP9012516_2

Thanks for all your help...Again