-
BannedUser
Reputation: 48
Cannot HO to neighbour cells !
Hi Bro
Pls help me for this problem:
We've just onair new-site, but when doing DT, MS only HO between sectors, cannot HO to neighbour cells:
- Check NBLs, OK
- No alarms about transmission, WSR, check hardware ( power, installing ) OK
- Change control Card ( SUMA, Alcatel BTS ).
- Delete all parameters and configure again
- Synchronous OK
Can anybody give me another solutions for this ?
Many tks for ur supports
-
2011-11-21 10:17 AM
# ADS
Circuit advertisement
-
Senior Member
Reputation: 331
Re: Cannot HO to neighbour cells !
Hi
is it just happening for one neighbor cell or all of its neighbors?
thanks
-
Post Thanks - 1 Thanks
-
Member
Reputation: 25
Re: Cannot HO to neighbour cells !
Hi,
May be there is a problem in MSC/BSC/RNC/LAC definition of the new cell. If the cell is created in BSC/RNC and not in MSC extenal handover is nor possible. Or if the LAC information is not truely defined for the neighbors again you may have problem..
-
Post Thanks - 1 Thanks
-
Member
Reputation: 139
Re: Cannot HO to neighbour cells !
Check for BTS Clock state.
We had observed similar problem once and we had to replace GTMU card.
Hope this helps
-
Post Thanks - 1 Thanks
-
Re: Cannot HO to neighbour cells !
what about the HO from neighbor cells to the new site?? and does it handover by forcing ??
-
Post Thanks - 1 Thanks
-
BannedUser
Reputation: 48
Re: Cannot HO to neighbour cells !
Originally Posted by
dear
what about the HO from neighbor cells to the new site?? and does it handover by forcing ??
TKs for ur reply
Neighbour cell cannot HO to this site, too. All HO is in better cell HO conditions , mate. No forcing
-
BannedUser
Reputation: 48
Re: Cannot HO to neighbour cells !
Originally Posted by
mudassar2k4
Check for BTS Clock state.
We had observed similar problem once and we had to replace GTMU card.
Hope this helps
GTMU card ? Did you mean GSM site controller and transmission card in Nokia system ? We use Alcatel BTS, and control card is SUMA, I replaced it . As mentioned, after replaced, one sector can HO normally, but 2 others cannot
Tks for ur repply
-
BannedUser
Reputation: 48
Re: Cannot HO to neighbour cells !
Originally Posted by
gencerali
Hi,
May be there is a problem in MSC/BSC/RNC/LAC definition of the new cell. If the cell is created in BSC/RNC and not in MSC extenal handover is nor possible. Or if the LAC information is not truely defined for the neighbors again you may have problem..
All parameters defined is OK, mate. Tks for ur reply ^^
-
BannedUser
Reputation: 48
Re: Cannot HO to neighbour cells !
Originally Posted by
dacoder
Hi
is it just happening for one neighbor cell or all of its neighbors?
thanks
It just happened in some neighbour cells, not all neighbour, mate. I checked all defined para, clock system, replaced SUMA, re_define site, but not OK
-
Member
Reputation: 37
Re: Cannot HO to neighbour cells !
check cgi. try delete and recreate again.
Bookmarks