Iub by Ip with Ps Rejects

[andoniwireless]

Hello all.. i have a site with Iub by Ip but it has rejects by Iub.. Someone know what i need to review.. Where you think will be the problem..

Tks

A

[Laughing]

Are there any alarms ??? Can you show me them ? Maybe I can help you

[veasna]

Hi Andoni,
There are steps for your checking as mentioned below:

1. Check alarm on the IuB congested sites, if there is not alarms related to IuB ,please go to step two.
2. Check the IuB utilization of the congested site by following this formula {(VS.IPDlMaxUsed.1(kbit/s)/ IuB BW }*100 , if it is higher than 90% please expand the IuB BW .

If you have any other concern please feel free to discuss.

Best regards,
veasna

[Laughing]

Hi veasna,

Can I ask you one question? For IuB utilization of congested site, How can I know the VS.IPDlMaxUsed.1(kbit/s) and IuB BW value ?

[gprastomo]

Hi you can get it on the counters.
You need to see the Iub utilization.

Hi veasna,

Can I ask you one question? For IuB utilization of congested site, How can I know the VS.IPDlMaxUsed.1(kbit/s) and IuB BW value ?

[agenov]

Probably if you have enough BW available over your Iub this problem is matter of incorrect Iub/IP configuration, double check your IP paths and etc.

BR
Alex

[veasna]

Hi Laughing,
VS.IPDlMaxUsed.1(kbit/s) is a counter which you can find it in M2000 by going to this path:

• Iub BW is a bandwidth of IuB that transmission team configure it for each site and you can check in CFGMML then going IPPATH.

If you have any other concern please feel free to discuss.

Best regards,
veasna

[andoniwireless]

Hi.. agenov & Vanesa.. as you told me i have enough capacity the site traffic is like 5 mbps and in my site configuration i have 25 mbps. Do you have some examples of a right configuration in the ippaths.

Regards
Andoni