-
Junior Member
Reputation: 10
Dual Band Handover Issue
I have observed several times during drive test that many of the 1800MHz cells delay in handing overs to thje 900Mhz cells.Sometimes they do not even handover to the 900 MHz cell even when the RXlevel for the 1800Mhz cell is very low and that of the 900cells are high.Though they are configured as neighbour cells.Has anyone experience this situation.How can I rectify this?
-
2011-08-17 12:37 AM
# ADS
Circuit advertisement
-
Junior Member
Reputation: 11
Re: Dual Band Handover Issue
Hi,
It is because of 1800 cells are set higher priority than 900 cells.
What kind of vendor do your company use?
-
Member
Reputation: 127
Re: Dual Band Handover Issue
Originally Posted by
Alphonso
I have observed several times during drive test that many of the 1800MHz cells delay in handing overs to thje 900Mhz cells.Sometimes they do not even handover to the 900 MHz cell even when the RXlevel for the 1800Mhz cell is very low and that of the 900cells are high.Though they are configured as neighbour cells.Has anyone experience this situation.How can I rectify this?
Hi mate;
You can control the layer threshold for band 1800 and make it near the band 900 but it is not recommended to make these two layers are in same level in case the band 900 is interfered by external interference.
Regards
E*******_RND
-
Junior Member
Reputation: 10
Re: Dual Band Handover Issue
Huawei is the vendor type.
-
Member
Reputation: 139
Re: Dual Band Handover Issue
-
Member
Reputation: 31
Re: Dual Band Handover Issue
Originally Posted by
Alphonso
I have observed several times during drive test that many of the 1800MHz cells delay in handing overs to thje 900Mhz cells.Sometimes they do not even handover to the 900 MHz cell even when the RXlevel for the 1800Mhz cell is very low and that of the 900cells are high.Though they are configured as neighbour cells.Has anyone experience this situation.How can I rectify this?
HI All,
I 'm also facing the same issue.
My vendor is e*******
Can anybody tell, what parameter to change?
-
Re: Dual Band Handover Issue
Are you sure that problem is related to UL/OL border thresholds ? What about congestion in UL - i vote for this
-
Re: Dual Band Handover Issue
Set ESI(Early sending Indication) to 1
-
Junior Member
Reputation: 11
Re: Dual Band Handover Issue
Hi,
If you use Huawei with Algorithm I, cell 1800 can't hand over to cell 900 by better cell (layer handover, PBGT handover). Two kind of handover need you change are EDGE handover and BQ handover.
Edge HO DL RX_LEV Threshold
Edge HO UL RX_LEV Threshold
UL Qual. Threshold
DL Qual. Threshold
Note: Be careful conflict with UL RX_LEV Upper Threshold/DL RX_LEV Upper Threshold; UL Qual. Lower Threshold/DL Qual. Lower Threshold(Power control parameter)
Last edited by rentalove; 2011-08-18 at 10:59 AM
-
Member
Reputation: 31
Re: Dual Band Handover Issue
Originally Posted by
finedeniz
Set ESI(Early sending Indication) to 1
i have checked Alex library for ESI, but it turned in 0 result.
Could u tell what is the winfiol command to change esi value and its range.
Bookmarks