Contents
1 Basic Principle
1.1 Definition
1.2 Theory Introduction
1.3 Recommended Formula
1.4 Signaling Procedure and Statistical Point
2 Influencing Factors
3 Analysis Process and Optimization Methods
3.1 Analysis Process
3.1.1 Procedures for RxQuality Problem Location
3.2 RxQuality Optimization Methods
3.2.1 Poor RxQuality on Entire Network
3.2.2 Passive Intermodulation
3.2.3 Intra-Network Interference
3.2.4 Inter-Network Interference
3.2.5 Hardware Fault
3.2.6 Huawei Anti-Interference Technology
3.2.7 Test Tool and Recommendations
3.2.8 Recommendations for Configuration and Test
4 RxQuality Optimization Cases
4.1 Low RxQuality in Kenya
4.2 Enabling Idle Burst Causing Interference Increase and Low RxQuality
5 Information Feedback
5.1 TEMS Test Log of Faulty Cell
5.2 Requirements for Existing Network Configuration Data and Traffic Measurement
without pass , enjoy it
Koepret
==================
Please Kindly add thanks and my reputation , if you fell usefull
Contents
1 Basic Principle
1.1 Definition
1.2 Theory Introduction
1.3 Recommended Formula
1.4 Signaling Procedure and Statistical Point
2 Influencing Factors
3 Analysis Process and Optimization Methods
3.1 Analysis Process
3.1.1 Procedures for RxQuality Problem Location
3.2 RxQuality Optimization Methods
3.2.1 Poor RxQuality on Entire Network
3.2.2 Passive Intermodulation
3.2.3 Intra-Network Interference
3.2.4 Inter-Network Interference
3.2.5 Hardware Fault
3.2.6 Huawei Anti-Interference Technology
3.2.7 Test Tool and Recommendations
3.2.8 Recommendations for Configuration and Test
4 RxQuality Optimization Cases
4.1 Low RxQuality in Kenya
4.2 Enabling Idle Burst Causing Interference Increase and Low RxQuality
5 Information Feedback
5.1 TEMS Test Log of Faulty Cell
5.2 Requirements for Existing Network Configuration Data and Traffic Measurement
without pass , enjoy it
Koepret
==================
Please Kindly add thanks and my reputation , if you fell usefull
Dear
Thanks for your nice Doc i saw in one doc huawei Feature call UISS do you have any document about it as the updated Huawei interference is EICC.
Hey was just going through the document and found this feature about enabling Idle Bursts....can anyone eloborate on this feature I mean what does it actually signify and whats the exact parameter for this function. Thanks
Bookmarks