Could the congestion be a reason of handover failure ??
I mean if (Handover Command) message is found , can I consider the congestion one of the reasons ?
check the attach
yes, it can. HO block due to no channel then will be directed or back to old
But some engineers told me that if the MS got the the handover command message that means that a traffic channel was found and so no congestion on the target cell.
Could the congestion be a reason of handover failure ??
I mean if (Handover Command) message is found , can I consider the congestion one of the reasons ?
check the attach
I advise you check the stats for the intended Target cell before concluding cos u could experience HO failures due to so many reasons.
I advise you check the stats for the intended Target cell before concluding cos u could experience HO failures due to so many reasons.
yes of course I know
but my question is :
even though the MS got the 'handover command' message, Could the congestion be a reason in this case , or as soon as the MS get this message I can't think of the congestion?
Bookmarks