Antenna Kathrein 80010306 performance

[RFDude_PMA]

Gentlemen URGENT

I have a question that I know many of you had experience so far UMTS network deployment. The antenna pattern we use is 68H7V 80010306 kathrein, but according to field measurements it looks like an Omni antenna.

Do you know another antenna that on the field it is performing like a real 65H and a good FtB isolation..

[RFDude_PMA]

Gentlemen

Somebody had experiment with this antenna?

[kilisuci_kdr]

Gentlemen URGENT

I have a question that I know many of you had experience so far UMTS network deployment. The antenna pattern we use is 68H7V 80010306 kathrein, but according to field measurements it looks like an Omni antenna.

Do you know another antenna that on the field it is performing like a real 65H and a good FtB isolation..

Dude, what measurement did you had?
Is it from drivetest result then you get 360 degree had the same SC?
This kind of antenna is sectoral which have frequency range from 790-960MHz.

[adewijaya]

did you have read for technical review of this? what spesific problem occured?

[RFDude_PMA]

Has I wrote before, it is a 65 panel that according to the drive test we can collect SS measurements -69 to -78 at 120, 180 or at the back of the antenna lobe.
The specs suggest that is a very low attenuation ladder from 65o to 180o. For a UMTS network this is critical we can see SC all over the place. Do you use this antenna or what kind of antenna you use for a 3 sector Node B configuration?

[Ummi]

How many set for Mechanical and Electrical Tilt then height of antenna?

[RFDude_PMA]

it varies a lot bcz is not one site. But let’s look at this scenario height 30m urban area with 10E tilt in all 3 sectors. We have ss around 500 to 900m around, describing something like 120 sector coverage but also some spots at the back

[RFDude_PMA]

Anybody is using this antenna? for a UMTS 3 sector node configuration?

appreciated