Moshell - AvgPropDelay Value

[sonerss]

Hi members

I want to ask AvgPropDelay in moshell

I took a pmr report in nodeb and it gave me AvgPropDelay value showed in below picture.. What is the quanity value of this value? Km, mile, or somewhat?? (Sector=1,Carrier=1 AvgPropDelay=0.7)

[sonerss]

Anyone know this???

Hi members

I want to ask AvgPropDelay in moshell

I took a pmr report in nodeb and it gave me AvgPropDelay value showed in below picture.. What is the quanity value of this value? Km, mile, or somewhat?? (Sector=1,Carrier=1 AvgPropDelay=0.7)

[mickeyknox]

Hi members

I want to ask AvgPropDelay in moshell

I took a pmr report in nodeb and it gave me AvgPropDelay value showed in below picture.. What is the quanity value of this value? Km, mile, or somewhat?? (Sector=1,Carrier=1 AvgPropDelay=0.7)

Hi Dude,

As i know, it should be in km. I attached a BO report related to Propagation Delay. Please check it first. It is also measured on PRACH. So Moshell and this report should produce same result.

[riyantoyadi]

yes, confirm

From Moshell must be in KM

[ltecity]

You can find Very Good Explanation
http://www.finetopix.com/showthread....nDelay-counter

[rffreeconsult]

The GSM/UMTS systems have been specified by ETSI (European Telecom Standard Institute) therefore the values are in the metric system. In the case of propagation delay, the unit is km. The value shown (0.7) is 0.7 km (700 m). It is valid in Umts. But please be aware that in GSM, the unit for Propagation Delay differs a little bit because it measures in TA unit (TIMING ADVANCE unit).