Thanks Thanks:  0
Showing results 1 to 7 of 7

Thread: Disable Power control for a cell in E///

  1. #1
    Moderator Reputation: 473
    Join Date
    2009-05-02
    Location
    Nearby
    Posts
    1,237


    Default Disable Power control for a cell in E///

    Hi Friends,


    Can any body explain what will happen if we disable Power control in some cells ?


    Suppose cells are located in Rural or Dense area.


    By which parameter we can Disable Power control?


    Thakns

  2. # ADS
    Circuit advertisement
    Join Date
    Always
    Location
    Advertising world
    Posts
    Many
     

  3. #2
    Member Reputation: 139
    Join Date
    2010-03-24
    Posts
    189


    Default Re: Disable Power control for a cell in E///

    Disabling power control will result in increase in interference in urban environment.But in rural areas you can disable this to increase coverage.

    If u like this pls add reputation.

  4. #3
    Moderator Reputation: 473
    Join Date
    2009-05-02
    Location
    Nearby
    Posts
    1,237


    Default Re: Disable Power control for a cell in E///

    Quote Originally Posted by mudassar2k4 View Post
    Disabling power control will result in increase in interference in urban environment.But in rural areas you can disable this to increase coverage.

    If u like this pls add reputation.
    by which parameter and command we can Disable it?

  5. #4
    Member Reputation: 139
    Join Date
    2010-03-24
    Posts
    189


    Default Re: Disable Power control for a cell in E///

    On which vendor are you working???

  6. #5
    VIP Member Reputation: 1593
    Join Date
    2010-03-17
    Location
    Paradise
    Posts
    823


    Default Re: Disable Power control for a cell in E///

    Quote Originally Posted by mudassar2k4 View Post
    On which vendor are you working???
    E*******, of course.
    Knowledge is nothing unless it is shared!
    https://www.youtube.com/c/ptt3i

  7. #6
    Member Reputation: 44
    Join Date
    2009-03-24
    Posts
    217


    Default Re: Disable Power control for a cell in E///

    In e******* :
    Cell level : DMPSTATE --> INACTIVE
    DBPSTATE --> INACTIVE
    AMRPCSTATE --> INACTIVE , for AMR connection

  8. #7
    Junior Member Reputation: 10
    Join Date
    2010-11-02
    Posts
    6


    Post Re: Disable Power control for a cell in E///

    The aim with BTS Power Control is to increase the number of MSs with sufficiently good C/I. BTS Power Control will improve C/I if traffic is maintained, or maintain C/I when traffic is increased or tighter frequency re-use is realised. The gain is obtained by a reduction of the over all interference level (I) in the network
    When MS Power Control is used by all MSs in the network, the total amount of radiated power is reduced. This implies that the uplink co- and adjacent channel interference in the network is reduced. The C/I will be increased for connections with low signal strength or with bad quality using full MS output power, since they experience a reduced interference level. On the other hand, the C/I is decreased for connections with high signal strength and good quality since they are subject to a reduced MS output power. The C/I reduction will however not affect the speech quality since these connections have a margin to the lowest tolerable C/I.

    DBPSTATE:Dynamic BTS power control state(ACTIVE/INACTIVE)

    DMPSTATE:Dynamic MS power control state(ACTIVE/INACTIVE)

Bookmarks

Bookmarks

Posting Rules

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •