-
Junior Member
Reputation: 10
traffic sharing
Dear expert,
I want to share traffic from DCS to GSM and GSM to DCS for some sites.
there is anyone can share what kind of paramater i should to tuning/change to make traffic sharing beetwen dcs to gsm n vice versa. i want to make one of them (dcs/gsm) more aggressively to handle traffic.
I'll appreciate if there is anyone can share knowledge. experience, or document related to this subject.
BR
Last edited by ebol; 2010-07-21 at 04:12 PM
-
2010-07-21 04:08 PM
# ADS
Circuit advertisement
-
Senior Member
Reputation: 397
Re: traffic sharing
It is very difficult to share the traffic, try to set up the same layer on dcs and gsm cells, and than with CLS feature. This is not very popular. Another way is to try with LAYERTHR.
-
Junior Member
Reputation: 12
Re: traffic sharing
it depends if you are using concentric cells or dual band cells..
in general if dual BCCH , you might need to play on the cell reselect offset to select the prefered cell in the idle mode ..if it is concentric you will need to set the prefered band and tune the outer to inner HO threshold as per your wish.
For example as normally DCS is inner if it is not the prefered band ..u have to make inner-->outer threshod wth higr signl levl
-
Member
Reputation: 238
Re: traffic sharing
Hi
on which vendor your working??
-
Junior Member
Reputation: 10
Re: traffic sharing
Originally Posted by
plannerguy
Hi
on which vendor your working??
right now, i optimize for ZTE n SIEMENS Network
can u give me a suggestion, what should i change(paramter) to share traffik from GSM to DCS?
-
Member
Reputation: 43
Re: traffic sharing
last week i balance traffic betwwen 1800 and 900 for huwaei equipment and give me good result en terms traffic balance.
900 :
cell layer:3
cell priority: 3
1800:
cell layer:2
cell priority:1
but you should study site by site.
and also try to play with tilt and hight.
-
Re: traffic sharing
Why not reduce or increase the HO margin between theses cells
-
Member
Reputation: 238
Re: traffic sharing
Hi
For siemens just change the DCS and GSM thrsesholds
ie HORXLVDLI and HORXLVDLO
Regards
Plannerguy
-
Member
Reputation: 18
Re: traffic sharing
Originally Posted by
plannerguy
Hi
For siemens just change the DCS and GSM thrsesholds
ie HORXLVDLI and HORXLVDLO
Regards
Plannerguy
Hi Plannerguy,
What is HORXLVDLI and HORXLVDLO? is this parameter located in BTS or BSC?
Thank you..
B.R.
-
Member
Reputation: 16
Re: traffic sharing
Originally Posted by
ebol
right now, i optimize for ZTE n SIEMENS Network
can u give me a suggestion, what should i change(paramter) to share traffik from GSM to DCS?
In dual band site you can increase CRO of the cell which is having low traffic,Also change PBGT margins in way e.g
i want to share traffic from 1800 to 900
PBGT (1800 ->900) 28
PBGT (900 -> 1800) 32
you can play with margins after observing the results of changes.
One more thing to keep in mind is if you are shifting traffic from 900 to 1800 in dual band site.normally 900 cells have more coverage and if you just try to share the traffic using parameters it might result in poor kpi's so try to check TA stats and reduce coverage of 900 cells through titls so that if it doesnt effect the network quality.
Bookmarks