Here are the guidelines for a software upgrade dimetra IPS/C. The attached files take you step by step on how to load config files and application files . The following is the sequence of steps;
...
Type: Posts; User: kideoIP; Keyword(s):
Here are the guidelines for a software upgrade dimetra IPS/C. The attached files take you step by step on how to load config files and application files . The following is the sequence of steps;
...
If I can ask a question on what you working on, are you doing the DMO gateway? and, is it possible to use an MTM5XXX radio as a gap filler or to repeat a TMO signal?
Hi, here is the link to a document guide.
https://www.4shared.com/s/fv7qCvgozjq
Hi Everyone,
I have an MTM5400 that is corrupted and I don't have a backup codeplug to do recovery. I have however managed to create a backup file using the other radio with the same version....
Hi EVERYONE!!
Thanks to everyone for the depot tool, however, i am trying to recover a corrupted radio. I have created a backup codeplug from another radio with same version. Now when I try to...
does anyone know where i can fin the AIS file ; kernel factory_upstart for an MTM5400? Im atleast trying to restore the mobile, i will deal with the MTP after successfully with mobile
Thanks, where can i get the AIS file? i see you wrote "attached bin file"
Ok, thanks I have managed to build one. Then from there? there seems to be a file that i need to have because when i try to "detect radio via RS323' it says i must start from ; tools>freon UART> then...
Hi again, I have managed to get the depot CPS, connected programming cable to the radios. would you kindly walk me through the steps or process of this recovery because i noticed that the radios are...
Thanks, I think i did some some threads on net suggesting a cps depot. The depot is different from the normal CPS? I will look for it.
Yes I have connected the IS, the LED (D402) on the board keeps flashing but the radio does not turn on.
Another info; radio was working before it went to this current status of not wanting to...
I am testing it on the bench, with a 12V power supply. as mentioned when i press the power up button the on board LED flashes green and then red, before it goes off
HI everyone,
I have a MTP3550 and a MTM5400 that are not switching on.
I have checked the fuses on the MTM and seems to be working and when supply is connected and power on button is pressed,...