"www.finetopix.com" is the pass
Type: Posts; User: Muhammad; Keyword(s):
"www.finetopix.com" is the pass
Hi Dear
Can you please share again. The link is unavailable
The most frequent sources in 800 MHz band are due to the PIM or CATV leakage (In case you have Cable TV networks in your country). The Audio component of the TV signal spans over 200 ~ 400 Khz. check...
Can you share the exact frequencies of the UL bandwidth in your region.
Power Boost refers to increasing the Reference Signal power by the calculated amount (10 log(1 + Pb)). The total transmit power remains 20 watts but you can achieve greater coverage. However, the...
This formula works on the background Noise and bandwidth of signal only.
BR
Jamil
External LAC definition are done at the core side if 2G and 3G MSC are different. In this case the wrong definition or no definition may lead to IRAT failures. Actually the MSC has no info to route...
Actually this sort of issue is faced when your External cell definitions at 3G end are not consistent with 2G side. Either the mismatch in Cell ID, LAC / BSC ID may lead to IRAT HO failures. If this...
Actually the RSSI should be calculated as
Noise floor (RSSI) = -174 + Noise Figure (Equipment specific) + 10 log (Bandwidth)
In LTE a RB consists of 180kHz so 10 log (180,000) =...
Repo Please if it helps you.
Can you please upload this again. I am in need of this tool, please.
BR
Check for the SPU capacity as well. I think in such SPU capacity will be less than DPU boards.
BR
Repo please if it helps you.:(
Actually in CDMA/EVDO DPUDb boards have the limitations of two types
Simultaneous connections
Flux as DPUDb board in CDMA can support upto 190 Mbps of combined flux (in upload and download...
In Huawei, LST BTSLNK
Because when the UE or MS starts acquisition, it has no synchronization info so to enable a MS to successfully decode and detect CPICH or Pilot channel, The transmit power of CPICH in WCDMA and Pilot...
Dear Can you upload these on 4shared
can you please upload these on 4shared