Yes, you can use it for Tx provided you are configured for that.
Type: Posts; User: ohms_law; Keyword(s):
Yes, you can use it for Tx provided you are configured for that.
You can use the EM state for 21 days to test our the license.
Hello,
Does anyone know how to get the Rx Throughput test to run in BTS Site Manager for LTE? The test runs but only reports error.
I am commissioning a LTE Flexi enodeB with a FSMF and a FRIE radio. I commision for 3 cells;
Cell 1: ANT 1 Tx/RX,ANT 2 Rx
Cell 2: ANT 3 Tx/RX,ANT 4 Rx
Cell 3: ANT 5 Tx/RX,ANT 6 Rx
Cells 2...
All,
Nice article regarding Verizon using the new E******* Radio Dot small cell solution.
Attached is the step by step instructions for RBS6601. Enjoy!
I am trying to load a CV that was generated in a DUL with R29 into a DUL that is running R32. When I reload the site, I get the following error:
Core MP stopped due to too many restarts...
Thanks. That helps a lot, but I am getting the same error whenever I attempt to change the Channel Number in the EUtranCellFdd Managed Object.
That is, I select the action change frequency and...
I am setting UE parameters in an RBS6601 site. I am getting an error with the qrxlevmin setting that I am out of range @ -115 dBm. That value is in range and Element Manager will not let me set...
Hello,
I have an RBS 6601 with a DUL that I can interface correctly to using Element Manager. I replaced the DUL with another, and even though I can ping it, I cannot connect to it.
The...
I am using the warpA ipwr 0 command to read tx and rx power on the RRU. If I feed in a -90 signal into the RRU, the power reported is 43.8.
I am not sure how to interpret the results. Is this Tx...
Hello,
I am trying to perform an RSSI test on an eNodeB RBS6601. Is there a way to measure RSSI with Element Manager or Moshell?
Thanks!
Please see the attached install manual
I am looking for a script to configure an E******* DUL in an RBS6601 that will turn on the RF so that it can be analyzed with a Spectrum Analyzer.
The RBS is not connected to the network.:cool:
Theres not much to it. Run the fiber from the RBS to the RRU. Take the 7/16 RF output to the Antenna or TMA.
Could you please share the method for comission the RBS 6601 without a connection to the network. That is, standalone with a laptop only.
Thanks.