I´m looking for the MOTOTRBO Flashzap II Client.
The Flashzap I Client does not work in it full range on newer radios.
Dieter
Printable View
I´m looking for the MOTOTRBO Flashzap II Client.
The Flashzap I Client does not work in it full range on newer radios.
Dieter
ls it this one ?
https://ibb.co/FKJs1nZ
No,this is the Flashzap Client I.
Dieter, do you need the FZ-II for SLR-5500, 5700 and 8000 repeaters? There is a simple solution to bring that modells in FZ-mode.
For that, you need only an old 25-pin Sub-D plug. Connect pin 4 to pin 9 and pin 18 to pin 24. Turn off the transceiver-repeater. Plug the D-sub plug to the AUX socket and turn the SLR on. Now you are in FZ-mode.
For the small SLR-1000 there is till no solution for FZ-mode.
Gábor
No,I need it for my bad DP1400.I hope there´s something in,like in Flashzap Client I,to bootstrap the radio via RS232.
Dear Dieter,
Some interesting information:
Your DP1400 has the UART-port on the PCB.
There are 4 pots: https://ibb.co/23Hyhsr
(blue, purple, green a ned red -check the photo). If you connect this pots to ground, you got low level. For the 1,8V Factory UART interface you need high level.
The interface, and the diagram: https://ibb.co/fqs605c
To boot the radio through the UART port you ned the Upstart Kernel (i dont have it).
Gábor
Well known stuff!
The upstart kernel is the problem.I hope there is one in the Flashzap II Client.Flashzap Client I also comes with such a file.