View Full Version : E******* BSC Synchronization help needed
cocola
2010-03-25, 02:51 PM
Hi . Could any one tell me, how to find out which dip that BSC can get the clock synchronization signal ? I only know that our BSC get the clock signal from SDIP. But how can we find which dips in the SDIP send the clock synchronization signal to SDIP???? Here is my problem:
CLOCK-REFERENCE STATE
REF STATE BLS
0ETM2,MS-0 UPD
0ETM2,MS-1 EX
Please help me. Thanks alot. :L
cocola
2010-03-27, 08:43 AM
No one help me. :confused:
Hi . Could any one tell me, how to find out which dip that BSC can get the clock synchronization signal ? I only know that our BSC get the clock signal from SDIP. But how can we find which dips in the SDIP send the clock synchronization signal to SDIP???? Here is my problem:
CLOCK-REFERENCE STATE
REF STATE BLS
0ETM2,MS-0 UPD
0ETM2,MS-1 EX
Please help me. Thanks alot. :L
first you have to locate the 0STM card one cable is going from this STM board to CLM-890 board that is your case. We are not connecting any cable to any dip it’s from STM board to CLM-890 clk board if you need External clk then it's different
zee86
2010-05-23, 08:34 AM
Hi . Could any one tell me, how to find out which dip that BSC can get the clock synchronization signal ? I only know that our BSC get the clock signal from SDIP. But how can we find which dips in the SDIP send the clock synchronization signal to SDIP???? Here is my problem:
CLOCK-REFERENCE STATE
REF STATE BLS
0ETM2,MS-0 UPD
0ETM2,MS-1 EX
Please help me. Thanks alot. :L
0ETM2,MS-1 EX means its working fine with the protection card of 0STM= first STM of that BSC
zee86
2010-05-25, 11:10 AM
Hi . Could any one tell me, how to find out which dip that BSC can get the clock synchronization signal ? I only know that our BSC get the clock signal from SDIP. But how can we find which dips in the SDIP send the clock synchronization signal to SDIP???? Here is my problem:
CLOCK-REFERENCE STATE
REF STATE BLS
0ETM2,MS-0 UPD
0ETM2,MS-1 EX
Please help me. Thanks alot. :L
bro your MS-1 is activated
that means you sync clock had some problem
or your in MS-0 there was some problem occur
but now you can switch back the EX to MS-0
by blocking the MS-1
roloramos
2010-05-28, 01:54 PM
I supouse that is one BSC E*******?...
In this case, You can find dip with command:
TPCOP:SDIP=sdip;
TPSTP:SDIP:sdip;
NTCOP:SNT=snt;
I hope to be of your help
cocola
2010-05-28, 02:37 PM
thanks for your useful help.
vBulletin® v4.2.5, Copyright ©2000-2024, Jelsoft Enterprises Ltd.