PDA

View Full Version : Tems 9.0 command sequence problem



keytox
2010-02-05, 12:21 AM
hi all,
i have a problem, I must make a drive test with tems 9.0, now, I m connecting all ms,.then when I running test from command sequence, tems is locking and not responding. If I run MSs by manual after connected them,.there is no any problem. this is true especially for 2 and more MS. is anybody get this problem before or have an idea about it_?

mirza
2010-02-05, 05:15 PM
hi all,
i have a problem, I must make a drive test with tems 9.0, now, I m connecting all ms,.then when I running test from command sequence, tems is locking and not responding. If I run MSs by manual after connected them,.there is no any problem. this is true especially for 2 and more MS. is anybody get this problem before or have an idea about it_?

Hello


This problem is usually seen in TEMS better connect all phones and include waits and loop in command sequence that way it should get some time so it will not get the problem

Thanks

Mirza

keytox
2010-02-07, 03:19 AM
Hello


This problem is usually seen in TEMS better connect all phones and include waits and loop in command sequence that way it should get some time so it will not get the problem

Thanks

Mirza

actually, after connect all phones,,. for a while there was not any problem but,. 5 maybe 10 minutes later ,. tems was locked and then not responding,. so it was crashed,.
i m not sure this is directly tems problem or another software,. the problem is still going on,. maybe tems9.0 bug or ...,. i dont know :S,. i need help