Flashzap II Client

[Dieter Bohlen]

I´m looking for the MOTOTRBO Flashzap II Client.
The Flashzap I Client does not work in it full range on newer radios.

Dieter

[vr10]

ls it this one ?

https://ibb.co/FKJs1nZ

[Dieter Bohlen]

No,this is the Flashzap Client I.

[580-Gabor]

Dieter, do you need the FZ-II for SLR-5500, 5700 and 8000 repeaters? There is a simple solution to bring that modells in FZ-mode.
For that, you need only an old 25-pin Sub-D plug. Connect pin 4 to pin 9 and pin 18 to pin 24. Turn off the transceiver-repeater. Plug the D-sub plug to the AUX socket and turn the SLR on. Now you are in FZ-mode.
For the small SLR-1000 there is till no solution for FZ-mode.

Gábor

[Dieter Bohlen]

No,I need it for my bad DP1400.I hope there´s something in,like in Flashzap Client I,to bootstrap the radio via RS232.

[580-Gabor]

Dear Dieter,

Some interesting information:
Your DP1400 has the UART-port on the PCB.
There are 4 pots: https://ibb.co/23Hyhsr
(blue, purple, green a ned red -check the photo). If you connect this pots to ground, you got low level. For the 1,8V Factory UART interface you need high level.
The interface, and the diagram: https://ibb.co/fqs605c
To boot the radio through the UART port you ned the Upstart Kernel (i dont have it).

Gábor

[Dieter Bohlen]

Well known stuff!
The upstart kernel is the problem.I hope there is one in the Flashzap II Client.Flashzap Client I also comes with such a file.