tonyM
2020-03-27, 08:57 AM
Hello everyone,
I want to try activation of LTE900MHz (Band-8) on this model by QPST. This band isn't found on standard configuration.
I have TEMS-phone of this model (MSM8960, Android.4.0.4, ver.9.0.1.D.0.10-TEMS).
The phone was rooted successfully by towelroot, installed SuperSU. Qualcomm drivers installed: in Diag-Mode LT25i detects as several USB-devices (diag, modem, serial, adb) with VID_0FCE&PID_5146, and drivers found at LT18i-driver pack.
Diag-port (USB-dev=VID_0FCE&PID_5146&MI_04) activated:
adb shell
su
setprop persist.usb.eng 1
setprop sys.usb.config diag.adb
But QPST can't find any phone behind diag-port. I tried everiting, but without success: port is open/visible, but no active phone at this port.
I don't know what is the problem with diag-port:
- drivers
- forbidden access to modem at TEMS-firmware
With modem, found as USB-dev=VID_0FCE&PID_5146&MI_02, no problem with communication (WindowsDeviceManager->ModemProperties->Diagnostics->QueryModem).
I don't have standard LT25i to check.
I checked on standard LT18i (ArcS) and standard D2303 (M2)- they are visible by QPST through diag-port (NV-memory is accessed).
Do you have experience on this topic ? Any ideas/help?
Regards,
I want to try activation of LTE900MHz (Band-8) on this model by QPST. This band isn't found on standard configuration.
I have TEMS-phone of this model (MSM8960, Android.4.0.4, ver.9.0.1.D.0.10-TEMS).
The phone was rooted successfully by towelroot, installed SuperSU. Qualcomm drivers installed: in Diag-Mode LT25i detects as several USB-devices (diag, modem, serial, adb) with VID_0FCE&PID_5146, and drivers found at LT18i-driver pack.
Diag-port (USB-dev=VID_0FCE&PID_5146&MI_04) activated:
adb shell
su
setprop persist.usb.eng 1
setprop sys.usb.config diag.adb
But QPST can't find any phone behind diag-port. I tried everiting, but without success: port is open/visible, but no active phone at this port.
I don't know what is the problem with diag-port:
- drivers
- forbidden access to modem at TEMS-firmware
With modem, found as USB-dev=VID_0FCE&PID_5146&MI_02, no problem with communication (WindowsDeviceManager->ModemProperties->Diagnostics->QueryModem).
I don't have standard LT25i to check.
I checked on standard LT18i (ArcS) and standard D2303 (M2)- they are visible by QPST through diag-port (NV-memory is accessed).
Do you have experience on this topic ? Any ideas/help?
Regards,