View Full Version : Traffic Balance between 3G Layers:
this command is used for traffic balancing
MOD UINTERFREQNCELL:RNCID=310,CELLID=11054,NCELLRNCID=310,NCELLID=11057,SIB11IND=TRUE,IDLEQOFFSET1SN=0,IDLEQOFFSET2SN=0;
Can anyone tell me how to use this command to push traffic from a layer to another
Best Regards
justdream
2019-08-25, 06:28 PM
Use this formula:
MOD UINTERFREQNCELL: RNCId=XXXX, CellId=”High load cell”, NCellRncId=XXXX, NCellId=”Low load Cell”, SIB11Ind=TRUE, IdleQoffset1sn=0, IdleQoffset2sn= -5;
IdleQoffset1sn: offset for neighbor measured RSCP
IdleQoffset2sn: offset for neighbor measured EcNo
If these parameters set to a greater value, the probability for selecting the neighboring cell as the target cell reduces. If these parameters set to a smaller value, the probability for selecting the neighboring cell as the target cell increases.
mounir34
2019-08-26, 05:24 PM
dears
this configuration is useful if you have continus coverage for all 3G Frequency,thanks
this command is used for traffic balancing
MOD UINTERFREQNCELL:RNCID=310,CELLID=11054,NCELLRNCID=310,NCELLID=11057,SIB11IND=TRUE,IDLEQOFFSET1SN=0,IDLEQOFFSET2SN=0;
Can anyone tell me how to use this command to push traffic from a layer to another
Best Regards
vBulletin® v4.2.5, Copyright ©2000-2024, Jelsoft Enterprises Ltd.