View Full Version : Looking for hasl HL emulator for industrial equipment
graemeian
2015-03-14, 11:07 PM
I purchased a piece of industrial equipment that is used and the software dongle is lost. I am currently relearning assembly codes using Ollydbg. I understand the common commands. Is there a way to software emulate the dongle without initially having the dongle? If so, please provide some guidance. Thank you.
hp3hp3
2015-03-15, 12:05 AM
what is your software name ?
I purchased a piece of industrial equipment that is used and the software dongle is lost. I am currently relearning assembly codes using Ollydbg. I understand the common commands. Is there a way to software emulate the dongle without initially having the dongle? If so, please provide some guidance. Thank you.
graemeian
2015-03-15, 12:38 AM
Smith Roboto Suits
hp3hp3
2015-03-15, 12:53 AM
what is your soft version?
do u have installer link ?
Staubli Robotics Suite
graemeian
2015-03-15, 12:58 AM
No, but I have the zipped software.
hp3hp3
2015-03-15, 01:02 AM
upload this for check
No, but I have the zipped software.
graemeian
2015-03-15, 01:19 AM
I do not see where I can upload through this forum. The Size is 400,000 Kb.
ian1196 at hotmail dot com
hp3hp3
2015-03-15, 01:24 AM
http://www.4shared.com
http://www.mediafire.com/
I do not see where I can upload through this forum. The Size is 400,000 Kb.
ian1196 at hotmail dot com
graemeian
2015-03-15, 04:02 AM
I just sent you a PM with a link.
www.nodongle.biz
2015-03-15, 07:34 PM
I just sent you a PM with a link.
Could you send me link to the protected software too?
Seems I did solution for that software before.
vBulletin® v4.2.5, Copyright ©2000-2024, Jelsoft Enterprises Ltd.